Do Canadian Carriers Need a Washington Oversize Permit?
Table Of Contents
-
Introduction
-
The Short Answer
-
What Washington Law Says
-
Washington's Legal Size and Weight Limits
-
Why a Provincial Permit Doesn't Work in Washington
-
Pilot Cars for Canadian Loads
-
Other Credentials You May Need
-
Metric vs Imperial Measurements
-
Quick Checklist
-
Common Mistakes to Avoid
-
Why Many Trucking Companies Choose Our Service
-
FAQ
Introduction
Washington shares a long border with British Columbia, and crossings like Blaine, Sumas, Lynden and Oroville see heavy freight every day. Logging equipment, machinery, modular buildings and steel all move south from Canada into Washington.
When a load is bigger or heavier than normal, Canadian carriers often ask whether their provincial permit is enough. It isn't. This guide explains when a Canadian carrier needs a Washington Oversize Permit, what limits trigger it, and which other credentials need to be ready before the truck reaches the border.
The Short Answer
Yes. Any vehicle or load that goes over Washington's legal size or weight limits needs a Washington Oversize Permit, no matter where the carrier is based. Washington's rules apply to the truck on the road, not to the carrier's home province.
-
A carrier from British Columbia hauling an over-width excavator needs the same permit as a carrier from Spokane.
-
A carrier from Alberta hauling an over-height tank needs it too.
-
A load that stays within legal limits doesn't need an oversize permit.
What Washington Law Says
Washington sets its size and weight limits in Chapter 46.44 RCW. The Washington State Department of Transportation (WSDOT) issues permits for loads that go over those limits, and the operating rules, including pilot cars, signs, travel times and routes, are in Chapter 468-38 WAC.
The law doesn't make an exception for foreign carriers. A permit is tied to the vehicle, the load, the dimensions and the route. WSDOT reviews a load from Vancouver, B.C. the same way it reviews one from Tacoma.
Washington's Legal Size and Weight Limits
A Washington Oversize Permit is needed when a vehicle or load goes over limits such as:
-
Width: 8 feet 6 inches
-
Height: 14 feet
-
Length: limits depend on the combination, such as a 53-foot semitrailer
-
Weight: 105,500 pounds gross for qualifying combinations, plus axle and bridge limits
The load must also be non-divisible, meaning it can't reasonably be broken into smaller pieces.
Why a Provincial Permit Doesn't Work in Washington
Canadian carriers often hold oversize permits from BC, Alberta or another province. Those permits cover provincial roads only.
-
No reciprocity: a provincial permit has no value once the truck crosses into Washington.
-
Different limits: some provinces allow heavier gross weights than Washington. A truck that is legal at home may still be overweight in Washington.
-
Each state is separate: a load heading past Washington into Oregon or Idaho needs a permit for each of those states too.
What it means for you: check the load against Washington's limits, not the provincial ones, before the trip is booked.
Pilot Cars for Canadian Loads
Large loads in Washington may need pilot cars. Under WAC 468-38-100, the triggers depend on the road and the load:
-
Over 11 feet wide on a two-lane highway: pilot cars are required.
-
Over 14 feet wide on a multilane highway: a rear pilot car is required.
-
Over 105 feet long on a two-lane highway: a rear pilot car is required.
Pilot car drivers must hold a certification that Washington accepts, and the cars need the right signs, lights and height poles where required. A Canadian escort that meets provincial rules may not meet Washington's, so check before the load reaches the border.
Other Credentials You May Need
A Washington Oversize Permit covers size and weight only. A Canadian truck may also need:
-
Washington Trip Permit: Canadian provinces are part of the International Registration Plan (IRP). If Washington isn't on the cab card, the truck needs a trip permit.
-
Washington Fuel Permit: a truck without IFTA needs a temporary fuel permit for Washington.
-
FMCSA registration: a Canadian carrier running in the U.S. needs a USDOT number and the right operating authority.
A single oversize trip can need all three Washington permits, so order them together and make sure the dates line up.
Metric vs Imperial Measurements
Canadian carriers measure loads in meters and kilograms. A Washington Oversize Permit uses feet, inches and pounds.
-
4.15 meters of height is about 13 feet 7 inches, under Washington's 14 feet.
-
4.3 meters of height is about 14 feet 1 inch, already over it.
-
47,854 kilograms is about 105,500 pounds.
Convert carefully and round up. A permit with the wrong dimensions isn't valid for the load on the trailer.
Quick Checklist
-
Is the Load Over Washington's Limits? Check the width, height, length and weight in feet, inches and pounds.
-
Is the Load Non-Divisible? If it can be broken down, it must be.
-
Are Pilot Cars Required? Check the width and length triggers for the route.
-
Is Washington on the Cab Card? If not, add a Washington Trip Permit.
-
Does the Truck Have IFTA? If not, add a Washington Fuel Permit.
-
Is the Route Clear? Check bridges and height limits from the border crossing to the destination.
Common Mistakes to Avoid
-
Assuming a provincial permit carries over. It doesn't.
-
Relying on provincial weight limits. Washington's may be lower.
-
Rounding metric measurements down. A small error can make the permit invalid.
-
Using escorts that don't meet Washington rules. Check certification and equipment.
-
Forgetting the trip and fuel permits. The oversize permit doesn't cover registration or fuel tax.
Why Many Trucking Companies Choose Our Service
Washington Trucking Online helps Canadian carriers get the right Washington Oversize Permit, trip permit and fuel permit before the load reaches the border, so a cross-border move isn't held up at the crossing.
-
Oversize permit: $98
-
Trip permit: $95
-
Fuel permit: $95
We provide support 24/7 and also work weekends and holidays.
or
FAQ
Do Canadian carriers need a Washington Oversize Permit?
Yes, if the load goes over Washington's size or weight limits. Provincial permits don't work in Washington.
Can I use my BC oversize permit in Washington?
No. Each state and province issues its own permit for its own roads.
When does a Canadian load need pilot cars in Washington?
For example, over 11 feet wide on a two-lane highway or over 14 feet wide on a multilane highway.
Does a Canadian truck also need a Washington Trip Permit?
Only if Washington isn't on its IRP cab card.
Does a USDOT number replace the oversize permit?
No. A USDOT number is federal, and the oversize permit is a Washington credential.
For more information, visit the Washington State Department of Transportation.